HVAC Installation Near Me in Culver City: Cooling and Heating Replaced as One Job

You typed "hvac installation near me" because a Culver City house needs a new system, and you want a crew that can handle the cooling and the heating together. We install both. If you are ready to price it, ask for the written quote here and we will book the sizing visit.

What the cooling side costs

A typical single-family AC installation in Culver City runs between $7,500 and $14,000 depending on system size, efficiency tier, and whether your ductwork needs replacement or sealing. That is the figure for the central air half of the job.

The heating half has no single number we can honestly print, because it depends on what you choose. A gas furnace, a heat pump and a ductless setup all price differently. The quote lists each option as its own line, written before any work starts, so you can see what the second system adds to the first.

Why one visit beats two

When cooling and heating are replaced in separate years, the same house gets opened up twice. The air handler, the return and the duct connections are touched once for the AC and again for the furnace. Doing both together means one permit filing, one inspection, and one day your power and airflow are interrupted.

It also changes the sizing. We run a Manual J load calculation for the house, then pick equipment to match the load, not the old nameplate. A split system that serves both seasons is sized from one set of numbers instead of two guesses made years apart.

What decides your total

• Home type. A bungalow, a duplex and a mid-century single-family house each have different attic and crawlspace access.
• System choice. Central air with a furnace, a heat pump that does both jobs, or ductless heads where there is no duct space.
• Ducts. We pressure test the ducts the new equipment will push air through. Sections that leak are sealed or replaced, and that goes on the quote as a separate line.
• Electrical. Some installs need a new disconnect or a circuit change. We check the panel on the visit.
• Permit. Culver City runs its own building and safety division, and we file the mechanical permit.

If your home is in Culver Crest, Blair Hills, Fox Hills or Del Rey, the same checklist applies. The street changes the access, not the process.

What you get on the visit

• A load calculation for the house, not a rule of thumb.
• A look at the existing air handler, line set route, pad and electrical.
• A duct pressure test, so you know whether the ducts stay.
• Two or three equipment tiers, each with a price.

Under Title 24 Part 6, California's Building Energy Efficiency Standard, a change-out or duct work can require duct sealing and a leakage test verified by a third-party HERS rater who is not the installer. Depending on the scope, we tell you up front whether your job triggers it, so it is not a surprise on day three.

After the visit, the quote arrives in writing with the equipment, the ducts, the electrical and the permit each on their own line. You can approve the whole thing, take only the cooling side, or ask us to reprice a different tier. Nothing starts until you say yes.

Replacing one system or both

You do not have to do both. If only the AC has failed and the furnace still runs, we quote the AC alone and show you where the furnace would fit later. If the furnace is the problem, see heating installation. Either way, the written quote names what is replaced and what stays.

Serving the Culver City area, we work on single-family homes, duplexes and small rental buildings. For multiple units, each system is quoted and logged on its own line.

Questions people ask before booking

Can you replace the AC and the furnace in the same visit?

Yes, when the house has both systems and you want both changed. The permit and inspection cover the whole job, and the quote shows each system separately.

Who pulls the permit?

We do. Culver City runs its own building and safety division, and a new AC system or a full replacement needs a mechanical permit from it. We file the application, book the inspection and meet the inspector.

What if my ducts are in bad shape?

We pressure test them before the quote. Leaking sections are sealed or replaced, and that work is priced as its own line so you can see its cost apart from the equipment.

Can I choose a heat pump instead of a furnace?

Yes. A heat pump handles cooling and heating, so it can replace both pieces of equipment. We size it by load calculation and quote it next to the furnace option.

What if I only need the AC?

Then we quote the AC alone. The range above is for that job, and heating is left out unless you ask for it.

Book it

Call (877) 409-5227 and tell us what you want replaced. We will set the sizing visit and put the quote in writing before any work begins.