AC and Heating Installation in Mar Vista, CA
Replacement systems for Mar Vista tract homes, with the central return and flex duct on the plan.
Plan an Install in Mar Vista
Tell us the address and what the current system is. We call back to set up a walkthrough and the load calculation.
Mar Vista ZIP code coverage
We plan and install new systems in these Mar Vista ZIP codes, and take install jobs near Mar Vista and Palms from here too.
What we install in Mar Vista
For homes in mid-century residential neighborhood on the Westside, we take on new AC and heat pump installs, full system replacements, ductless heads, and new ductwork, with repair and tune-ups after, working around mid-century ranch homes and renovated bungalows.
AC Installation in Mar Vista
New central AC sized by load calculation for Culver City bungalows, hillside homes, and condo buildings, with the permit filed and the install day planned around whoever lives there.
View local service →AC Repair in Mar Vista
Repair on systems we installed or inherited, with a plain answer on whether the unit is worth fixing or due for replacement before you spend on it.
View local service →AC Maintenance in Mar Vista
Tune-ups that keep a newly installed system running the way it was set up on day one: coils, drain, refrigerant charge, and airflow checked against the install readings.
View local service →Ductless Mini Split in Mar Vista
Ductless heads for Carlson Park bungalows with no attic duct space, converted garages, and condo units where a building will not allow new duct runs.
View local service →Heating Installation in Mar Vista
Gas furnace and heat pump installs for Culver City houses and rental units, sized by load calculation, with floor furnace replacements a common starting point.
View local service →Heating Repair in Mar Vista
Furnace and heat pump repair in Culver City, with a straight read on whether an old floor furnace or tired heat pump should be replaced instead.
View local service →Install planning notes for Mar Vista
The post-war tract homes in Mar Vista were built around one central return and a shallow attic, so a straight equipment swap without opening up that return and swapping out flattened flex duct just moves the same airflow problem to a newer unit. Where a rear addition was tacked onto the original duct trunk, we typically size a dedicated ductless head for that room rather than chase it with more capacity everywhere else.
Home Types
We size and route equipment around mid-century ranch homes and renovated bungalows.
Climate & Environment
Morning marine layer is reliable enough here that peak cooling loads stay moderate most of the season, but the moisture it brings still has to factor into unit sizing rather than get treated as a footnote. That same ocean air pushes salt a few miles inland, so we spec coated coils and hardware that hold up better than uncoated parts do closer to the valleys.
Nearby Areas
Homes near Mar Vista, Palms, and Venice fall in the same service run.
Walkthrough First
Every Mar Vista install starts with a walkthrough at the property, then a load calculation and a written estimate.
Next Step
Replacing a system in Mar Vista?
Call or send the address and we will set up a walkthrough. You get the sizing, the equipment options, and the permit plan in writing before anything is ordered.